Elaine, West Virginia as a whole participated in the TAZUP program and the whole state is covered. If all of the available data can be tabulated by TAZ it would be very helpful to us. Jack Pascoli -----Original Message----- From: Elaine Murakami [mailto:Elaine.Murakami@igate.fhwa.dot.gov] Sent: Friday, March 08, 2002 4:16 PM To: ctpp-news(a)chrispy.net Subject: [CTPP] What Geographic Summary Levels will be included in CTPP? Chuck Purvis asked the question last week. Here is a list of our current plan. WE WANT YOUR INPUT on the additional geographic levels. Some are only possible for RESIDENCE-based tables. Whether you want them or not, please provide us with your feedback! Maybe since the GIS capabilities and experience are so much better now than 10 years ago, no one needs to have these levels included in the file, since you and your staff can aggregate them from TAZ or Block groups directly. You can reply either to me directly (elaine.murakami(a)fhwa.dot.gov) or you can post to the listserv (ctpp-news(a)chrispy.net) Here are the basic levels, but not the detailed information. State State-County State-County-MCD (in selected states) State-County-Place (2,500+) State-Place (2,500+) State-County-Combined Zone -- Combined zones are limited to combinations of tracts or TAZs. They will be defined by the State DOTs (if they choose to do so) and are intended to assist Statewide travel demand models, where the small TAZs of an MPO are too detailed for Statewide applications. State-County-Tract * Tracts will be included, even in areas with TAZs. State-County-Tract-Block Group* State-County-TAZ * *The smallest unit of tabulated geography can be TAZ, Block Group, or Tract Possible levels (if there is any interest) For the 3 geographic levels listed below, we would like to know if there is any interest in having these included for RESIDENCE tables. Because of workplace geocoding difficulties, we cannot use these geographic levels for WORKPLACE or FLOW tabulations. 1. ZCTA (ZipCode Tabulation Area) This is an approximation of a Zipcode boundary. 2. PUMA (Public Use Microdata Area) These are areas with a minimum of 100,000 population based on tract or place boundaries. 3. Urbanized Area (areas with more than 50,000 population with the required density level) For the 2 geographic levels listed below, it is likely that the Census Bureau could include these for RESIDENCE and WORKPLACE tables. 1. CTPP Region: This will be defined by each MPO. It will be one or more whole counties submitted by the MPO as constituting their CTPP region. Totals for the sum of the counties included in the CTPP Region will be a separate summary level for the RESIDENCE and WORKPLACE tables. The FLOW tabulation will include the smallest unit of geography for each county. All counties are not required to have the same unit, e.g. 3 counties may use TAZ, and 1 county may use tracts. TAZs can be used only if they have been defined in the TAZ-UP process. 2. MPO Study Area: This is a list of TAZs (by county) or tracts (by county) to be submitted by an MPO for which RESIDENCE AND WORKPLACE tables can be prepared. Totals for the sum of these TAZs (or tracts) will be a separate summary level for the RESIDENCE and WORKPLACE tables. This special geography is provided as a convenience. An MPO planning area might not include whole counties, but we required TAZs to be defined across an entire county. By adding this summary level, a total that does not extend to county boundaries can be easily found on the CTPP file.